Seam repair
Open seams are sealed with tape or fabric and coating where most leaks begin.
Most mobile home roof leaks in Lodi start at panel seams, screw holes or dried sealant around vents, and all of them can be repaired without replacing the roof. One call to (551) 394-0610 reaches a nearby roofer who works on mobile homes.
Leaks on a manufactured home roof tend to follow a predictable pattern. The roof might be metal panels, an EPDM or TPO membrane, or asphalt shingles on a pitched roof, depending on the age and model of the home. For metal roofs, panel seams, fastener holes and dried sealant at vents and the perimeter edge cause most leaks.
Water does damage quickly in a manufactured home. Ceiling panels, particleboard and fiberglass insulation soak up water, so a leak that looks minor can leave stained or sagging ceilings, soft floors near walls and mold above the ceiling. If a ceiling panel bulges with trapped water, a small hole at the low point lets it drain into a bucket, keeping clear of light fixtures, and power to that area should be shut off at the panel if it is safe to reach.
Climbing on a mobile home roof is riskier than it looks. Weight should go on the trusses, not between them, which is why roofers often use boards to spread their weight. Stay off a wet or icy roof, and look for the data plate inside the home, which shows the roof load the home was designed for.
If the problem goes deeper than it first looked, a Lodi roofer may also recommend roof coating or metal roof repair.
Looking for Lodi mobile home roof repair? Call (551) 394-0610 and describe the problem to a roofer who works in Lodi.
Call nowThe fix depends on the roof type and how far the water has spread.
Every seam, screw, vent and edge is checked, along with low spots where water sits. Inside, ceiling stains help point to where water is getting in.
Missing or loose screws are replaced and panels are secured so the roof stops rumbling. Rusted spots are cleaned and treated before sealing.
Open seams are covered with seam tape or fabric embedded in coating. Membrane roofs get matching patches and seam repairs instead.
Vent caps, skylights and the AC curb get fresh sealant or new flashing, and cracked vent covers are replaced. The perimeter edge where roof meets wall is sealed as well.
On metal and some membrane roofs, a full elastomeric or silicone roof coating is applied after repairs to seal small gaps and reflect sun. Coatings need dry weather and a clean surface to bond.
Open seams are sealed with tape or fabric and coating where most leaks begin.
Panels are secured with new screws to close leaks at every screw.
Rotted sheathing or framing under leaks is repaired before new roofing goes over them.
A reflective coating covers the roof to keep the home cooler.
Penetrations get fresh sealant or new flashing where needed.
A full mobile home roof replacement is the answer when rust, rot or a worn membrane has spread across the roof. Replacement may include new sheathing over the trusses, fresh insulation and a new roof of metal, rubber membrane or TPO. Damaged trusses are fixed first.
A mobile home roof replacement in Lodi starts with the trusses, since the new roof has to stay within what they can carry. Ask whether a permit is needed, since manufactured homes can have their own rules. The goal is a roof that sheds water and stays quiet in the wind for years.
A mobile home roof over installs a new roof on top of the existing one instead of tearing it off. The most common types are a pitched roof over with trusses and shingles or metal, a flat roof over with insulation board and a single ply membrane, and a metal roof over on furring strips. Many roof overs add insulation, cutting heat gain and making the home quieter in storms.
Before a roof over on a Lodi mobile home, the added load and the way the new roof ties into the walls have to be worked out. Pitched roof overs in particular may need engineering and a permit, and they should be anchored to resist wind uplift. Done well, a roof over can stop chronic leaks and add years to the home.
In Lodi, many mobile homes still have their original low slope metal roof, while newer ones were built with shingles. From Lodi out to Hasbrouck Heights, Garfield, Maywood and Hackensack, most mobile home roof calls come down to seams, screws and sealant around vents, while older roofs that have leaked for years often need a roof over instead.
For mobile home roof repair in Lodi, NJ or nearby towns like Hasbrouck Heights, Garfield, Maywood and Hackensack, call (551) 394-0610 to reach a roofer who covers your street.
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Lodi is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Local roofers see the same roofs and storm damage across Lodi and nearby towns.
Ask your questions before you agree to anything.
More questions? Call (551) 394-0610
A seamless coating over a sound but weathered roof, when the roof underneath is still dry and solid.
Learn moreRepairs for leaking fasteners, open seams, rusted panels and failed flashing on a metal roof, without replacing panels that are still sound.
Learn moreRepairs for leaking rubber roofs, from peeling seams to pulled flashing at walls and curbs, never with tar or asphalt cement that ruins the rubber.
Learn moreFinding where water gets through the roof and sealing it at the source, so the stain on the ceiling stops growing.
Learn moreLooking for something else?
See all roofing servicesCall (551) 394-0610 for a local roofer in Lodi and nearby towns.