Perimeter repair
Membrane pulling from walls is released and reflashed to stop tears at the perimeter.
Flat Roofing
Rubber Roof Repair Lodi, NJ
A Lodi roofer who works on EPDM can fix peeling seams, punctures, blisters and membrane shrinkage at walls and curbs, so the roof stays watertight for more seasons. One call to (551) 394-0610 reaches a nearby rubber roof repair pro.
Most EPDM leaks come from a short list of problems. Seams lead the list, since older EPDM roofs were often seamed with liquid adhesive that breaks down over time. Punctures and failed flashing at walls, curbs and vents round out the usual causes.
Shrinkage is a problem specific to rubber roofs. As the sheet contracts, it pulls on the flashing at walls and edges, lifts the membrane off inside corners and can tear the rubber where it bridges between the roof and the wall. Repairing shrinkage means relieving the strain and reflashing, not smearing sealant on the split.
Avoid one common shortcut before the roofer arrives. Petroleum-based patches attack the rubber and have to be scraped off before a real repair. For now, protect the inside, avoid the roof in wet weather and write down when the leak shows up.
Rubber Roof Repair is often paired with rubber roof installation and flat roof repair, depending on the cause.
Need rubber roof repair in Lodi? Call (551) 394-0610 and describe the problem to a roofer who works in Lodi.
Call nowThe process
What happens during a rubber roof repair
Here is how a roofer usually handles a rubber roof repair.
Locate the source
The inspection traces the leak from the stain back to seams, flashing and penetrations. If insulation is wet, it is cut out and replaced before patching.
Prepare the surface
The repair area is cleaned thoroughly, because dirt and chalky residue keep patches from bonding. Incompatible old patches come off before anything new goes on.
Prime the area
A rubber primer is applied and given time to dry to the touch. This step is what lets the patch bond chemically to aged rubber.
Seal the damage
A rubber patch extends well past the damage, gets rounded corners and is rolled to remove air. Odd shapes like pipe bases and inside corners get uncured flashing.
Fix the laps
Failed laps are reopened, cleaned and resealed with modern seam tape. Lap sealant is applied along exposed edges and T-joints.
Fix shrinkage
Where the rubber has pulled away, the roofer relieves the tension, adds new flashing up the wall and secures it with termination bar. New termination bar and counter flashing keep the top edge sealed.
What is included
Repairs a rubber roofer can handle
Surface renewal
Compatible coatings can extend the life of weathered EPDM to add years to the roof.
Lap sealing
Open laps are resealed with seam tape with lap sealant at the edges.
Pipe boots
Damaged collars around penetrations are renewed with pre-molded boots or uncured flashing.
Puncture repair
Punctures get a primed rubber patch rolled for a full bond.
Related service
EPDM Roof Repair Lodi, NJ
Every EPDM repair depends on the same steps, done in order. The rubber must be clean and dry, the primer must be scrubbed in and allowed to flash off and the patch must be rolled firmly so it bonds across its whole surface. A bead of lap sealant seals the patch edges.
In Lodi, rubber roof repairs are best done on dry days when the membrane is not too cold. In an emergency, a temporary seal can stop water until conditions allow a proper patch. The permanent repair should still follow the full process.
Related service
Rubber Roof Replacement Lodi, NJ
There comes a point where patching an EPDM roof stops being worth it. Seams failing all over, shrinkage pulling at every wall, a brittle and crazed surface or wet insulation across large areas all point toward a new roof. A moisture scan shows how much is still dry.
Replacement options include new EPDM or a heat-welded membrane like TPO. A tear-off is needed if the insulation is wet or there are already two layers. In Lodi, ask for both options so you can compare.
Local help
Rubber Roof Repair Near Me
In Lodi, EPDM is one of the most common membranes on low slope sections of homes. Across Lodi and nearby towns like Hasbrouck Heights, Garfield, Maywood and Hackensack, older rubber roofs most often need seam and shrinkage repairs, while newer ones mainly need puncture and flashing fixes, which keeps small leaks from becoming big ones.
Need rubber roof repair around Lodi? Call (551) 394-0610 for a Lodi roofer who serves the towns around it too.
What the local climate does to a roof
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Lodi is busiest after a hard winter and before the next one.
Why call
Why fix it now
Drier ceilings
Small roof problems caught early usually stay small repairs.
Roofers who know Lodi
Roofers in Lodi know the roof types and weather wear common in local homes.
Know what happens next
Ask your questions before you agree to anything.
Common questions about rubber roof repair
Can I use roofing tar on a rubber roof?
Asphalt-based products damage rubber roofing. The petroleum in them breaks down rubber and blocks real patches from sticking. The right fix is a primed EPDM patch.
What causes EPDM to pull away from the edges?
Shrinkage is the usual cause. Tension builds at walls and edges, and the flashing eventually tears. The fix is relieving the tension and adding new flashing.
Should I coat my EPDM roof?
Coatings can work on rubber roofs with proper prep. Repairs and a compatible primer come first, then the coating. A coating is not a fix for an active leak.
What is the lifespan of an EPDM roof?
A well installed EPDM roof commonly lasts 20 to 30 years. Roofs with good drainage and maintained seams last longest. Fixing small problems early protects the rest.
How is a rubber roof patched?
A proper EPDM patch is a cleaned, primed and rolled repair. After cleaning and priming, a peel-and-stick EPDM patch is applied and rolled. The edges get lap sealant.
More questions? Call (551) 394-0610
Often needed together
Rubber Roof Installation
New EPDM rubber roofs laid in wide sheets over insulation and a cover board, with primed and taped seams, with as few seams as the roof allows.
Learn moreFlat Roof Repair
Repairs for leaking flat roofs, from punctures and seams to clogged drains and wet insulation, with the patch made from material that bonds to what is there.
Learn moreRoof Coating
A seamless coating over a sound but weathered roof, when the roof underneath is still dry and solid.
Learn moreRoof Leak Repair
Finding where water gets through the roof and sealing it at the source, so the stain on the ceiling stops growing.
Learn more
Looking for something else?
See all roofing servicesTalk to a Lodi roofer about rubber roof repair
Call (551) 394-0610 for a local roofer in Lodi and nearby towns.