Headwall flashing
The flashing across the top of a roof section is redone and covered by the siding or counter flashing.
Roof Repair
Flashing Repair Lodi, NJ
A roofer in Lodi can repair or replace the step flashing, counter flashing, kickout flashing, valley metal and drip edge that seal the joints of a roof, woven correctly with the shingles and tucked behind the siding. One call to (551) 394-0610 reaches a nearby roofer who repairs flashing.
Wherever a roof meets a wall, a dormer, a skylight, a valley or an edge, it relies on flashing to keep water out. Along a sidewall, individual step flashing pieces interleave with every course of shingles, counter flashing covers their tops, and a kickout diverter at the lower end turns water away from the siding. When any piece is missing, loose or rusted through, water gets behind the roof covering.
Flashing leaks are sneaky because the water often runs into the wall instead of the attic. A missing kickout is a classic example: water running down the roof edge pours behind the siding at the bottom of the wall, and the rot shows up later as soft trim, stained siding or a damp window below. Catching it early keeps the repair to the flashing instead of the wall.
A bead of sealant along a joint is a warning sign, not a repair. Sealant can hold for a while, but it fails sooner or later, and the joint leaks once more. Proper flashing sheds water by gravity and lapping, so it keeps working even after any sealant ages.
If the problem goes deeper than it first looked, a Lodi roofer may also recommend chimney flashing repair or roof leak repair.
Looking for Lodi flashing repair? Call (551) 394-0610 to reach a nearby roofing contractor.
Call nowThe process
How flashing repair works
Good flashing work is mostly about the order things overlap.
Inspect the joint
The flashing is checked along its full length, from the eave up, along with the wall sheathing where it can be seen. Damage in the wall changes the scope, so it is checked early.
Remove siding
Siding is lifted or removed along the joint so the old flashing and housewrap can be reached. Working the new pieces in correctly depends on access behind the siding.
Install new flashing
Fresh step flashing goes in course by course with the shingles, starting with a kickout at the eave. Fasteners go into the roof deck only, never through the vertical leg into the wall.
Seal the wall side
On masonry walls, counter flashing is set into a cut joint; on framed walls, the housewrap and siding cover the flashing. That clearance keeps the siding from soaking up water at the roof line.
Finish the edges
At the roof edges, drip edge is reset or replaced to protect the fascia and deck edge. Correct laps at the edges keep water out of the fascia and soffit.
What is included
What flashing repair covers
Cap flashing
Cap flashing on masonry is reset into the mortar joint without relying on caulk alone.
Sidewall flashing
Loose or rusted step flashing is renewed behind the housewrap.
Kickout flashing
A kickout is added where a roof edge ends against a wall which protects the wall below.
Drip edge
Edge metal is renewed along the roof perimeter so water drips clear of the fascia.
Related service
Roof Flashing Repair Lodi, NJ
The scope of a flashing repair depends on the joint and on how much damage the water has done. Minor work includes refastening loose metal or adding a missing kickout; bigger jobs mean pulling siding and replacing every step piece along a wall. The roofer should explain which applies before work begins.
The metal used should suit the house. Copper outlasts most roofs, galvanized steel is durable and aluminum is light and easy to bend, though it corrodes in contact with wet masonry. Mixing copper with aluminum or galvanized metal in contact can cause corrosion, so the roofer matches the metal to what is already there.
Related service
Roof Valley Flashing Lodi, NJ
A valley is where two roof slopes meet, and it channels a large share of the roof water toward the eave. In an open valley, a band of metal stays exposed down the center, while in a closed or woven valley the shingles cover the valley and the underlayment beneath does the heavy lifting. A peel-and-stick underlayment down the valley is the backup layer in both styles.
Common valley problems include rusted metal, debris dams, worn shingles and nails placed too close to the centerline. Uncut shingle corners can catch water and direct it under the roofing. Valley repair usually means removing the shingles along the valley, replacing the membrane and metal and reshingling with the right cuts.
Local help
Flashing Repair Near Me
In Lodi, many flashing problems date back to an old reroof where the original flashing was reused or caulked instead of replaced. Across Lodi and nearby communities including Hasbrouck Heights, Garfield, Maywood and Hackensack, the age of the house and the number of roof-to-wall joints decide how much flashing work is likely, which is why roofers pay extra attention to walls, dormers and additions.
For flashing repair in Lodi, NJ or nearby towns like Hasbrouck Heights, Garfield, Maywood and Hackensack, call (551) 394-0610 to reach a roofer who covers your street.
How the weather here affects roofs around Lodi
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Lodi, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why not wait
Less damage
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers who know Lodi
Local roofers see the same roofs and storm damage across Lodi and nearby towns.
Clear next steps
Ask your questions before you agree to anything.
Flashing Repair FAQ
What is step flashing and why does it matter?
Along a sidewall, each shingle course gets its own small flashing piece that overlaps the one below. Because each piece laps the one below, water is passed down the wall joint from piece to piece and onto the roof. One continuous piece along a sloped wall lets water run under the shingles instead.
How do I know if my flashing is leaking?
Leaks near walls, dormers, skylights or valleys are the strongest sign. Outside, look for rust, gaps, lifted metal, nails through the face and heavy caulk along the joint. Soft or stained siding at the bottom of a sidewall often means a missing kickout. A roofer reached at (551) 394-0610 can look at every joint.
Can I just seal the flashing with caulk?
Sealant is a short-term patch for flashing, not a lasting repair. It shrinks and pulls away, then lets water in where nobody can see it. A proper repair replaces the metal so it sheds water without depending on sealant.
Can flashing be repaired without replacing the roof?
Flashing repair is a routine job on roofs that are otherwise sound. The work stays local to the joint, with new shingles woven in along it. If the roof is near the end of its life, it can make sense to replace flashing as part of a reroof instead.
Why does my roof need kickout flashing?
A kickout is a small diverter at the bottom of a roof-to-wall joint, where the roof edge ends against a wall. It turns water that runs down the step flashing outward into the gutter instead of letting it pour behind the siding. Without one, the wall below that joint often rots quietly for years.
More questions? Call (551) 394-0610
Related services
Chimney Flashing Repair
Chimney flashing rebuilt so the roof-to-brick joint sheds water again, so the ceiling beside the fireplace stays dry.
Learn moreRoof Leak Repair
Finding where water gets through the roof and sealing it at the source, so the stain on the ceiling stops growing.
Learn moreSkylight Repair
Skylight repair from the flashing on the roof to the glass and the frame, after sorting out whether the water is a leak or condensation.
Learn moreRoof Vent Repair
Fixing the vents and pipe collars that poke through a roof and often leak first, before a small crack soaks the attic.
Learn more
Looking for something else?
See all roofing servicesGet flashing repair help in Lodi
Call (551) 394-0610 to talk to a roofer serving Lodi, NJ.